Modes and Duration:

Resident - 8 Weeks 0.0 Days

Recommended Credit:

None

Scope:

Primary emphasis of training will be on maintenance supervision, shop operations, recovery operations and equipment, diagnostics and advanced troubleshooting on hydraulic system, electrical system, steering/braking system, engine and transmission assembly, and auxiliary power unit; maintenance of Test Measurement and Diagnostic Equipment (TMDE).

Special Information:

None

Prerequisites:

Active Army, Army National Guard, or Army Reserve enlisted personnel. Must have completed Phase 1 and 2 of 91H30 ALC. Selected by PERSCOM (Active Army) or recommended by unit commander (Reserve Component). Meets requirements in AR 350-1 and TABE. Active and Reserve/Guard Soldiers over 40 must complete required medical screening and receive status prior to attending. Only SSGs and promotable SGTs will attend. Successfully completed Warrior Leader Course (WLC) or equivalent unless promoted to linkage of NCOES to promotion. Successfully completed WLC at least 6 months prior to attending this course.

USASMA developed Advanced Leader Course (ALC) (formerly called BNCOC) Common Core distributed Learning (dL)/Video Teletraining (VTT) must also be completed to be considered a course graduate. This material may be completed before, during or after any Phase of this course.

All Advanced Leaders Course (ALC) students will be responsible for successfully completing the Commander's Safety Course (CSC) training via distributed learning (dL) at https://crc.army.mil (the CSC can be found embedded in the Composite Risk Management section) prior to attendance at ALC or at the eOrdnanceU website while attending ALC. Completion of this training is a mandatory graduation requirement. NOTE: If the student completes the training prior to attending ALC, the completion of the course will be tracked by the Combat Readiness Center Learning Management System (CRC LMS). Their system is capable of providing the student with a certificate of completion. The student will present this certificate upon arrival to ALC or during the course as evidence of completion.

Must complete 611-91H30-C45 (DL) Phase 1 before attending this resident Phase.

Contact Information:

Registration Assistance:

Contact: ALU Registrar
Phone: (804) 765-4152/4149/4122
DSN:            539-4152/4149/4122

Course Director:

Phone: (804) 765-8989/8988
DSN:            539-8989/8988

Mailing address: